Potter PFC-4410RC Manuel d'utilisateur télécharger pdf (Page 59)

PFC-4410RC • 5403550 • REV Q • 11/12

Program #22 Mode

1. Apply power to panel.

2. Move the program switch down.

3. Press the FUNCTION (bottom) button until the display reads “PASSWORD = 000”.

4.To enter a password, press the SELECT button until the proper number is displayed above the ^ symbol, then press the SET

button to move to the next digit. After entering the third number the display will change.

(All panels are shipped with a 000 password.)

5. Press the FUNCTION (bottom) button until the display reads “PROGRAM #0”.

6. Press the SELECT button until the display reads “PROGRAM #22”.

7. Press the SET button.

8. Press the SELECT button to change the pre-discharge time.

9. Press the SET button to enter the pre-discharge time displayed.

10. Preset the SELECT button to change the manual release pre-discharge time. See page 10 for abort mode selections.

11. Press the SET button to enter the manual release pre-discharge time displayed.

12. Press the SELECT button to change the abort mode.

13. Press the SET button to enter the abort mode displayed.

14. The panel is completely programmed except for the custom banner and zone messages. Move the program switch back up.

Description: Single Hazard, 2 detection zones cross-zoned to 1 release circuit. A manual station zone and a discharge

conrmation zone. Also rst and second alarm notication circuits.

Inputs: 1 supervisory zone, 3 detection zones, 1 manual station zone, 1 abort circuit

Outputs: 3 general alarm, 1 release circuit

Operation: Activation of either detection zones 1 or 2 will activate the alarm output #1

Activation of both detection circuits at the same time will activate the alarm outputs #1, #2 and start the pre-

discharge timer for the release circuit output #3

Activation of the manual release zone #3 will activate the alarm output #2 and start the manual release pre-

discharge timer for release circuit output #3

Activation of zone 4 will operate output #4

When either zone 1 or 2 is in alarm, output 1 will operate

When both zones 1 and 2 are in alarm at the same time, outputs #1,2 will operate and the pre-discharge timer for

output #3 will start

When zone 3 is in alarm, output 2 will operate and the manual release pre-discharge timer for output #3 will start

When zone 4 is in alarm, output #4 will operate

PROGRAM #22

ZONES

SUPERVISORY 2 #1 #2 #3 #4

OUTPUTS Supervisory Detection Detection Manual

Release

Detection

#1 FIRST ALARM X X

#2 SECOND ALARM X X X

#3 RELEASE XX XX X

#4 ALARM INDICATING X

SUP 1 defaults to abort

XX = Cross-Zoned

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 98 99

Commentaires sur ces manuels

Pas de commentaire

Potter PFC-4410RC Manuel d'utilisateur Page 59

Commentaires sur ces manuels

Produits connexes et manuels pour Sécurité Potter PFC-4410RC