Potter PFC-4410RC Manuel d'utilisateur télécharger pdf (Page 83)

PFC-4410RC • 5403550 • REV Q • 11/12

Custom Program (#0 only)

• Describe Initiating Zones 1 - 4

Alarm Zones Supervisory Zones

Detection Supervisory

Waterow Tamper

Linear Heat Detection Low Air

Manual Release Hi Air

Low Air Alarm

• Describe Initiating Zone 5 (dedicated supervisory)

Supervisory

Tamper

Low Air

Hi Air

Abort

• Describe Initiating Zone 6

Supervisory

Tamper

Low Air

• Describe Output Zones

Alarm Indicating

Releasing

eAEROSOL

Supervisory Bell

Trouble Bell

1) Releasing circuits: normal/cross-zoned

2) Discharge time: 7, 8, 9, 10, 20 minutes or continuous

• Map Alarm Inputs to Outputs

• Put in Banner Message

• Put in Banner Message Bottom Line

• Put Zone Description for Each Initiating Zone

• Change Password

• Finished

Installation Instructions

Read the entire manual before attempting to install this panel

This panel wiring should be installed and maintained in accordance with section 760 (Fire Protection

Signaling Systems) and all other applicable sections of the National Electrical Code, all other applicable NFPA Code and

Standards, local code and the authority having jurisdiction. Review the circuit parameters listed below before installing the panel.

Canada Installations

All wiring terminals support 14 to 22 AWG wire sizes. 18 AWG stranded or solid copper wire, (or wire size

rated for the current carrying capacity of the input and output circuit application), with 300V, 85°C insulation is recommended.

Wire checkout

With all initiating devices and notication appliances installed and with the EOLR’s in place, check the wires with an ohmmeter.

Meter readings outside of the following will prevent normal operation.

From any wire to ground – more than 100K ohms.

Across the 2 wires on each Initiating zone – between 1.8K ohms and 5.4K ohms.

Across the 2 wires on each notication circuit – between 1.8K ohms and 23.9K ohms.

This panel wiring should be installed and maintained in accordance with CAN/ULC-S524M, (Standard for the Installation of

Fire Alarm Systems), and all other applicable sections of the Canadian Electrical Code, all other applicable NFPA Code and

Standards, local code and the authority having jurisdiction. Review the circuit parameters listed below before installing the panel.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 98 99

Commentaires sur ces manuels

Pas de commentaire

Potter PFC-4410RC Manuel d'utilisateur Page 83

Commentaires sur ces manuels

Produits connexes et manuels pour Sécurité Potter PFC-4410RC